Pro-series 51077 51 Receiver Manuel d'utilisateur télécharger pdf

Installation Instructions

Jeep Wrangler

Jeep Wrangler Unlimited

Part Numbers:

51077

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 3/4”

Drill Bits: None

Crossmember

Rev. A10-9-0751077NSheet 1 of 3

z 2007 Cequent Towing Products

Conical WasherQty. (4)

Hex Bolt 1/2-13 X 4.50Qty. (4)

Tighten all 1/2-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 51077F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

350 (159 Kg)3500 (1589 Kg)

Weight Carrying

Ball Mount

400 (182 Kg)4000 (1816 Kg)

Weight Distributing

Max Tongue

WT (LB)

Max Gross

Trailer WT (LB)

Hitch type

Wiring Access Location: TBA

Form: F205 Rev A 5-6-05

Crossmember

Bumper

Spare tire

For vehicles with OEM Tow Hook: Tow hook must be permanently removed for hitch installation.

1. Lower exhaust. (If required)

2. Raise hitch into position.

3. Install fasteners as shown above.

4. Reinstall the vehicle exhaust. (If required)

1 2 3

Résumé du contenu

Page 1 - Installation Instructions

Installation InstructionsJeep Wrangler Jeep Wrangler Unlimited Part Numbers:51077Hitch Show

Page 2 - Instructions d’installation

Instructions d’installationNuméros de pièces :Attelage montré dans la position appropriéeÉquipement requis :Clés : 3/4”Mèche : AucuneRev. A10-9-075107

Page 3 - Instrucciones de instalación

Instrucciones de instalaciónNúmeros de partes:El enganche se muestra en laposición correctaEquipo necesario:Llaves: 3/4”Brocas de taladro: NingunaRev