Pro-series 51080 51 Receiver Manuel d'utilisateur télécharger pdf

Installation Instructions

Toyota Sienna

Part Numbers:

51080

Do Not Exceed Lower of Towing Vehicle

Fascia

Toyota Sienna

2011 and newer models: Hitch crosstube is visible beneath

bumper with a more than normal gap between fascia and crosstube.

Hitch Shown In Proper Position

Equipment Required:

Manufacturer’s Ratin

Wiring Access Location: SUV1, SUV2

Frame Rail

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

5,000 500

Weight Carrying

Ball Mount

3,500 350

To be reinstalled

Wrenches: 19mm

Drill Bits: None

Fastener Kit: 51080F

Existing Weldnut

3 Places

(Both Sides)

ote:

Area to be trimmed

reinstalled

Fasteners Typical

Both Sides

Area

trimmed

To be reinstalled

Figure 2

Sport Model

Qty. (6) Flat Washer, 1/2”

Qty. (6) Hex Bolt, M12 x 1.25 x 40mm

Qty. (6) Lock Washer, 1/2”

Area to be trimmed

Figure 1

For vehicles with appearance panel:

Remove appearance panel which covers the trunk pan. This panel will need to be trimmed or not reinstalled on vehicle. Ask vehicle

owner their choice before starting installation. See Figure 2

1. Lower the exhaust by detaching it from the rubber isolator.

2. Raise hitch into position and install hex bolts, lock washers and flat washers into existing weldnuts in frame, as shown above.

3. Raise exhaust back into position and reattach to the rubber isolator.

4. Reinstall trimmed cover panel removed. Or return untrimmed panel to vehicle owner.

z 2007, 2010, 2011 Cequent Performance Products

Sheet 1 of 3 51080N 1-7-11 Rev. C

Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.